Schematic (and PCB in next stage)

$30-250 USD

Fullført

Lagt ut

over 5 år siden

$30-250 USD

Betalt ved levering

Objective: Take several 1.5 volt disposable batteries and connect them in parallel to a transformer to produce an output voltage of 110 volts. The output power should be sufficient to power a standard LED/incandescent/compact fluorescent bulb. Implement: 1) Convert voltage from one or more 1.5 volt batteries connected in parallel to 110 volts; Output: 1) Schematic; 2) Layout diagram; This is stage 1 of a multi-stage project. Successful frictionless completion with result in a preferential right to subsequent stages.

Circuit Design

Electrical Engineering

Electronics

Microcontroller

PCB Layout

Prosjekt-ID: 18583577

Om prosjektet

4 forslag

Eksternt prosjekt

Aktiv 5 år siden

Ønsker du å tjene penger?

E-postadresse

Fordeler med budgivning på Freelancer

Angi budsjettet og tidsrammen

Få betalt for arbeidet ditt

Skisser forslaget ditt

Det er gratis å registrere seg og by på jobber

Tildelt til:

@Tomorrow1201

Take several 1.5 volt disposable batteries and connect them in parallel to a transformer to produce an output voltage of 110 volts. The output power should be sufficient to power a standard LED/incandescent/compact fluorescent bulb. Implement: 1) Convert voltage from one or more 1.5 volt batteries connected in parallel to 110 volts; Output: 1) Schematic; 2) Layout diagram; This is stage 1 of a multi-stage project. Successful frictionless completion with result in a preferential right to subsequent stages.

$150 USD om 3 dager

4,3

(8 omtaler)

4,8

@ayowealth

I will be glad to work on the project for you as an expert in electronic circuit designer. I graduated with horns in my first degree in Physics and electronics and since then I have been working on microprocessor and circuit networks. Kindly send me a message to take this project further. Thanks Ayo Ajayi

$100 USD om 3 dager

4,8

(12 omtaler)

4,9

4 frilansere byr i gjennomsnitt $153 USD for denne jobben

@Mestek

hello i am a computer engineer,i have masters in computer engineering,i have experience for more than 7 years in arduino and electronics i know how to make this circuit,but kindly note we will need rechargeable batteries not just AA disposable batteries to have a sufficient amps

$250 USD om 3 dager

5,0

(29 omtaler)

5,3

@Dinushkawajs

I will provide you the design with simulated results. Since this is a personaly interested area for me, i will give you a best and optimized design. And you need to provide me exact power requirements of the output for me to deliver a successful dsign. If you are planning to connect LED BULB, mention me the maximum power W which you may require. Otherwise design may fail if you draw more power. And this need to be designed with minimum power consumption.

$111 USD om 5 dager