Programming PIC Microcontrollers

Hello there I am an expert embedded software developer with 5 years of experience in that field. I have worked with the same microcontroller before + proteus ofcourse I would like to know which compiler do you use and see your code please contact me for more information

Hi. I have good experience in PIC programming and proteus simulation. If you give me a chance of interview, I will show my previous workings. Please let me discuss about your project in detail. Best regards, Andrii.

This bid is for verifying the power factor *measurement* and / or *display* only. If you need assistance with the power factor *correction* also, then I would need to treat that as an additional milestone. There are a number of reasons why the values might not be displayed correctly: 1. problem in the voltage / current sensing circuits 2. incorrect ADC configuration / readings 3. mistakes in calculating the voltage / current from the ADC readings or the power factor calculation code 4. problems in the LCD display routines Have you ruled out any or all of the above possibilities yet? I use MPLAB X IDE version 5 and the XC8 compiler. If your development environment is different please let me know. (I use Linux so do not think I will be to replicate your circuit simulation using Proteus unfortunately). I have some spare 8-bit PIC microcontrollers at hand - so would at least be able to verify the LCD display, the ADC routines and the power calculations. I am based in Ireland - GMT+1 timezone.

Hello Sir. I can help your project perfectly. I have 10 years good experience of hardware development including PIC programming. PIC16F877, PIC16F628, PIC18F46k22 etc. I have completed a variety of embedded system design and programming by using microcontroller, arm, etc Board PCB design have been completed by using Altium and Protel99SE. Hope to cooperate with you.

Hi I have 14 years experience in PIC microcontroller.I have both pic16f hardware and proteus simulator. Please share your code and simulation file I can debug and solve the issue We can discuss Regards Senthil Chennai, India

Hello I have more than 15 years of experience in the embedded systems design and pcb design and electronics systems design So let's discuss your project in chat note: I have more than 15 years experience with pic microcontroller .

YEs, dear i am available. I w0rk a lot on this microcontroller and simulate many projects on proteus software. let me know how i can help you. Thanks!

Hello.. I am an electrical and electronics engineer.. I have very good experience in pic microcontrollers programming.. I have gone through your requirements and I am sure that I can do this project perfectly.. Kindly drop me a message through chat and provide me further details.. Looking forward to hearing from you soon.

Hello, I have made similar curcuit using Arduino. I know the basic working principle of the circuit and programing. I can debug your code. Thank you.