OPTIMAL REACTIVE POWER DISPATCH OF POWER SYSTEM NETWORKS WITH DISTRIBUTED GENERATION USING PARTICLE SWARM OPTIMISATION

R210-1750 ZAR

Stengt

Lagt ut

over 6 år siden

R210-1750 ZAR

Betalt ved levering

The project is about optimal reactive power dispatch with distributed generation of a case study system ie (IEEE 14Bus ) using particle swarm optimisation. The project should be done in Matpower and the results should be validated using Newton Raphson method. The distributed generation(DG) should be a wind turbine,Enercon E82 E4 with a power rating of 2500kw, and can deliver 1.2Mvar of reactive power and arbsorb 1Mvar. The results should show a decrease in transmission power loss when the DG is connected and operating at full speed. You can follow the attached document.

Engineering

Prosjekt-ID: 15033501

Om prosjektet

6 forslag

Eksternt prosjekt

Aktiv 7 år siden

Ønsker du å tjene penger?

E-postadresse

Fordeler med budgivning på Freelancer

Angi budsjettet og tidsrammen

Få betalt for arbeidet ditt

Skisser forslaget ditt

Det er gratis å registrere seg og by på jobber

6 frilansere byr i gjennomsnitt R2 323 ZAR for denne jobben

@arslanuet123

Power engineer here to help u buddy Relevant Skills and Experience EE, Power engineering Proposed Milestones R1777 ZAR - required work

R1 777 ZAR om 3 dager

4,9

(32 omtaler)

5,3

@seshupower

Hi, I am a post graduate power electronics engineer and having very good experience in product design and development. I am excellent in SMPS, supplies design from few watts to KW range using Buck, Boost, Buck -boost, Push Pull and H-bridge inverters I am excellent in solar, wind, Micro grid, smart grid and IEEE bus systems development in MATLAB Simulink Design, PSPICE, PSIM ,MULTISIM and LTSpice , Proteus Simulations. I did many projects for MS and PhD thesis like grid connected solar, wind, wave energy grid connected systems using MPPT, Multi-level converters, Inverters with different control algorithms, hybrid systems development and D-STATCOMs, FACTS devices for power stability, quality and control electrical vehicles, inductor motors. I worked for vehicle design simulation for different applications. I use to design Solar with MPPT using buck, buck-boost topologies, Power quality and control using Active filters, Opamp based circuit, digital circuits etc. I understand your requirement and ready to work for you. Please contact me for further discussion.

R2 222 ZAR om 15 dager