Route USB Type C extension PCB in CircuitMaker

£10-20 GBP

Stengt

Lagt ut

over 5 år siden

£10-20 GBP

Betalt ved levering

Got a project where I need to extend a USB Type C via a circuit board. Require someone to route the schematic and PCB. There are only 2 components, the socket and plug. I have been advised that there is no need for any other components to extend the USB Type C. Using Wurth components 632723300021 and 632712000021. Will require doing it in CircuitMaker (it is all I have access to, and will be moving mount points later on, though no traces will be moved). Attached are photos of the PCB with 1.25mm grid. The PCB is set up with 4 layers. Don't want to go above this layer count. If an extra 1mm is required that is fine. Would like this done within the next few days ready for prototype manufacture.

Electrical Engineering

Electronics

Microcontroller

PCB Layout

Prosjekt-ID: 17929365

Om prosjektet

5 forslag

Eksternt prosjekt

Aktiv 5 år siden

Ønsker du å tjene penger?

E-postadresse

Fordeler med budgivning på Freelancer

Angi budsjettet og tidsrammen

Få betalt for arbeidet ditt

Skisser forslaget ditt

Det er gratis å registrere seg og by på jobber

5 frilansere byr i gjennomsnitt £52 GBP for denne jobben

@sagradoamicus

Hi I am experienced PCB designer I can do it for you. I have completed a number of projects here. Please review my profile to see the feedback from my previous employers Regards

£90 GBP om 2 dager

4,9

(255 omtaler)

8,0

@cebrax

Hello, You just need to connect A1 to A1, A3 to A3, B1 to B1 etc. You don't need to worry about the signal integrity since your trace length is going to be below 15 mm.. If you would like to obey the signal integrity rules, all you need to do is to obey differential routing of pairs DP1-DN1 in example, and making the power lines a little bit wide, 1mm or above.. I am happy to do this for you in a very short time if you could supply the file in the attached image or the required dimensions for the edges etc. But I need to say that I don't like the plug hanging out like that with no support. I don't understand why other bidders placed their bids so high.. It is a 3 hours job + the time for downloading and installing Circuit Maker.

£20 GBP om 2 dager

4,9

(9 omtaler)

4,3

@dimitarmirchev

Hello Sir/Madam, I would like to apply for your project. I am an EE based in Bulgaria with several years of experience in schematics development and pcb design. I am using AD 17. You can check my portfolio with some of my designs. My latest ones, not included in portfolio include USB Type C hubs, Ethernet to Type C/USB 3.1 A bridge, PoE modules, etc. I am awaiting your answer to my proposal, Dimitar Mirchev

£44 GBP om 1 dag

5,0

(2 omtaler)

1,9

@EmbeddedD

I will layout this PCB in 2 days using circuitmaker as requested with the required components. High speed traces need to be accounted for and it could be possible to do this on 4 layers.

£89 GBP om 2 dager

0,0

(0 omtaler)

0,0

@DreamingInCode

Hi this looks like a great first project for my freelance account. I have over 5 years of electrical design experience so this will be really easy. Any questions you have please let me know. Hope we work together. Thank you, Best regards, Emina

£18 GBP om 1 dag