Develop an oscilloscope using FPGA kit ZC706 and FMCJESDADC1 card

$250-750 USD

Kansellert

Lagt ut

over 6 år siden

$250-750 USD

Betalt ved levering

I am looking for FPGA guys who have done work on FMCJESDADC1 card, ZC706, RAM Controller, Petalinux. Please do not bid if you have not done work on this hardware. Anyone who is participating on bidding, please show me the examples of work you have done on this in past. 1. Take data from FMCJESDADC1 card using JESD204B (already implemented) 2. Perform analysis (FFT, etc) 3. Save Data in PL RAM 4. PS gets the data and send it to remote PC over TCP/IP. 5. PS has Petalinux installed 6. Use FPGA Drive (from Opsero) to save the data permanently.

Electrical Engineering

Electronics

FPGA

Verilog / VHDL

Prosjekt-ID: 16153219

Om prosjektet

5 forslag

Eksternt prosjekt

Aktiv 6 år siden

Ønsker du å tjene penger?

E-postadresse

Fordeler med budgivning på Freelancer

Angi budsjettet og tidsrammen

Få betalt for arbeidet ditt

Skisser forslaget ditt

Det er gratis å registrere seg og by på jobber

5 frilansere byr i gjennomsnitt $1 802 USD for denne jobben

@ahmedmohamed85

Dear sir I have implemented Spectrum Analyzer using ZedBoard, also i have done the same using ML605 board and 4DSP data acquisition card, i have more than 10 years experience in digital design using FPGA

$1 500 USD om 10 dager

4,9

(419 omtaler)

7,8

@eopskzs

I have previously worked with different families of Xilinx products and development platforms, including the zedBoard and ZC702 from Xilinx with high-speed video interfaces. I haven't used this specific board and FMC add-on hardware but they are pretty similar with what I have worked with. Please, feel free to contact over chat if you have any questions. Best regards,

$1 400 USD om 25 dager

5,0

(6 omtaler)

4,2

@bondwp322

Hi, I am an experienced programmer and I'm sure I can complete your project asap. Please contact me and tell about your project details. I promise a high quality and punctual work. Thanks. ProjectName:Develop an oscilloscope using FPGA kit ZC706 and FMCJESDADC1 card Relevant Skills: Electrical Engineering, Electronics, FPGA, Verilog / VHDL,

$555 USD om 4 dager