Nuvoton Microcontroller programmer for Composite USB device HID + Serial

$10-50 USD / hour

Kansellert

Lagt ut

nesten 6 år siden

$10-50 USD / hour

We have a project where we have the code to communicate with our two devices, but we need to write the "Glue" to combine them together into a USB composite device. Ideally you should use IAR and have knowledge of Subversion. We will use a Nuvoton NUC220 or NUC240. We cannot use a different micro-controller as it requires 5V IO .

C Programming

Microcontroller

Prosjekt-ID: 17337679

Om prosjektet

4 forslag

Eksternt prosjekt

Aktiv 6 år siden

Ønsker du å tjene penger?

E-postadresse

Fordeler med budgivning på Freelancer

Angi budsjettet og tidsrammen

Få betalt for arbeidet ditt

Skisser forslaget ditt

Det er gratis å registrere seg og by på jobber

4 frilansere byr i gjennomsnitt $41 USD/time for denne jobben

@seshupower

Hi, I am a post graduate power electronics engineer and having very good experience in product design and development. I am excellent in embedded design & programming using pic, dspic controllers and MATLAB codding for Power projects, Boot loaders, Bluetooth & GPS designs,CAN communication, EEprom. UART , RF circuits ,Protocols for networking, wi-Fi routers,OBD diagnosis with CAN bus protocols, Electrical vehicles and AC drives, stepper motor controls. I designed sine wave inverters for standalone and grid tie Inverters. I designed projects like Off line UPS up to 3 KVA, 5kW motor controller for electrical vehicles ,synchronous rectifiers, Solar MPPT chargers, Solar trackers, Battery chargers ,Grid tie inverters design with PLL and feedback control circuit emergency light of 66W and Online UPS control cards, Battery Charging power supplies, LED drivers for PWM controlling and dimming, SMPS, Power supplies. I have experience in schematics and PCB design experience in Altium and ORCAD. I am ready to work for you. Please contact for further discussion.

$44 USD om 40 dager