Generator autostart

Would like to be able to start and stop a generator using just one input (1)

Outputs needed

[login to view URL] control (linear actuator)

[login to view URL] control ( linear actuator)

[login to view URL] (relay)

[login to view URL] (relay)

[login to view URL] (relay)

[login to view URL] sensor grid side (relay)

8. voltage sensor gen side (relay)

9. Output on (relay)

10. Shutdown (relay)

Would ideally just set timers for all these things dependant on the particular machine I'm setting it up for eg. Start time may be different for differnt generators, throttle length might be different

Need remote access through ip address to be able to change these values can be done in cmd

Also ability to call in generator remotely through web and have redundant start up in case of certain value (grid failure)

Program might run something like

1=high

Then 3,4,5 on

8=high

5 off

Wait 15sec then 3 off

Wait 2min (warm up)

9 on

(shutdown sequence)

1=low

9 off

2 throttle down

Wait 30sec

6

4 off

If remote start called in from web

Start above sequence

If 7 low

Start above start up sequence until

10. High

Then

Run shutdown sequence

Python

Prosjekt-ID: #18854525

Om prosjektet