TestStand and LabVIEW program

€8-30 EUR

Kansellert

Lagt ut

nesten 4 år siden

€8-30 EUR

Betalt ved levering

Need and expert TestStand environment with LabVIEW to do a sequential test for a small Pump with heater.. The Software for the sequence is already done in Labview and we need to do the same test With TestStand using the PC example in TestStand tools as a template with Images and animation... We need also to simulate the Pump externally to test our sequence without the phisical module... This is a micro project and for an expert it would take a few hours since the LabVIEW part is already done...

LabVIEW

Arduino

Software Architecture

Electronics

Assembly

Prosjekt-ID: 26243177

Om prosjektet

4 forslag

Eksternt prosjekt

Aktiv 4 år siden

Ønsker du å tjene penger?

E-postadresse

Fordeler med budgivning på Freelancer

Angi budsjettet og tidsrammen

Få betalt for arbeidet ditt

Skisser forslaget ditt

Det er gratis å registrere seg og by på jobber

Tildelt til:

@hggujarati7

A Certified LabVIEW Developer with 3.5+ years of experience in design and development of Automated Test Equipment (ATE) systems using National Instruments (NI) Hardware & Software.

€111 EUR om 3 dager

0,0

(0 omtaler)

0,0

4 frilansere byr i gjennomsnitt €48 EUR for denne jobben

@PKonstiantyn

Hello, I am an Electrical and Electronics Engineer and I completed my master's degree. I have developed in TestStand environment with LabVIEW to do a sequential test for a small Pump with heater. I can simulate the Pump externally to test our sequence without the phisical module with labview. Thanks to the electronic circuit design programs I can use, I can design and test the circuit. I guarantee free support at all times if there is any problem when the project is over. Best regards! Konstiantyn.

€50 EUR om 2 dager