Robotic arm or electronics supply and design to open my intercom door station

Lukket Lagt ut 5 år siden Betales ved levering
Lukket Betales ved levering

Supply and delivery of one Robotic arm or electronics to answer my intercom system.

Overview.

I have an Intercom system that visitors can open the door by entering in a pin code to a keypad on the ground floor.(we are on the 20th floor)

This will make the telephone type handset ring.

The action required is to lift the handset and push a button located on the front of the intercomin the lower right corner.

Then replace the handset in its cradle. This will open the ground floor door.

Our house has two levels and if we are on the second level , we don't get time to get to the intercom to answer it .

The company that supplied the intercom advised that they can not put extra handsets in other locations in the house.

So I figure just use a robotic arm to do this .Or some simple electronics sound switch,servos,plunger ect)

Step 1 .Handset rings .

Step 2 after 3 seconds Lift handset.

Step 3 after 2 seconds push button.

Step 4 after 2 seconds replace handset.

Step 5 reset to start wait for next ring .

The handset is wall mounted but I can move it onto a shelf if needed.

Arduino Elektrisk ingeniørvitenskap Elektronikk Microcontroller PLC & SCADA

Prosjekt-ID: #16775003

Om prosjektet

12 bud Eksternt prosjekt Aktiv 5 år siden

12 frilansere byr i gjennomsnitt $591 for denne jobben

mechatronicsengr

Hi, I hope you are doing well. I have expertise in embedded system design and development with expertise in Robotics. I have reviewed your project details, and I wish to discuss so I can give you better solution Mer

$631 USD på 10 dager
(88 Omtaler)
6.8
adilme

Hi. This seems am interesting project. I can do it. Can you pls see my portfolio for implemented electronics projects and prototypes? I look forward to work on robotic arm handing intercom project.

$666 USD på 30 dager
(10 Omtaler)
4.4
alinayyar

A proposal has not yet been provided

$250 USD på 3 dager
(5 Omtaler)
2.6
VVV3PStudio

Hi, I am not electronic engineer but I can make you 3D model and animation, if you need that, for better explanation of what are you need to the right person, engineer. ;) I will do it for $100. Greetings, Vladim Mer

$250 USD på 3 dager
(0 Omtaler)
0.0
maksmusings

Hello, have 18 years exp. in intercom design and would love to work n this project. regards, Ali

$555 USD på 10 dager
(0 Omtaler)
0.0
einstine2020

Hello, I have a solution for you . I'm a mechanical and instrumentation engineer and I could device a circuit mechanism for you which would by pass the ring after two seconds and open .As an added level of security I Mer

$444 USD på 5 dager
(0 Omtaler)
0.0
BakshiGulam

In my humble opinion a Robotic Arm for your requirement may not be a good idea (due to it's inherent mechanical characteristics). Instead, I propose a Electronic/Computer based intelligent system which can (1) check Mer

$833 USD på 30 dager
(0 Omtaler)
0.0
Pjain58

A proposal has not yet been provided

$833 USD på 40 dager
(0 Omtaler)
0.0
LiaqatHumza

I have thoroughly read your project and fully understands your requirements. I am an Electronics Engineer with vast experience in robotics. I am ready to work on this project and eagarly waiting for your reply to futhe Mer

$460 USD på 10 dager
(0 Omtaler)
0.0
PrabhaKotha

The working of telephone is very simple, When you get a call, a high voltage signal is sent to your phone which makes the phone ring. When you lift the handset, the switch under it is released, which disconnects the ri Mer

$277 USD på 10 dager
(0 Omtaler)
0.0