ODB2 scanner via gprs... A prototype that has the following OBD processor GPS /GPRS....

$30-250 AUD

Kansellert

Lagt ut

omtrent 6 år siden

$30-250 AUD

Betalt ved levering

I need a full device with all the chips in one board. Not using modules..... A name has to be printed as the PCB is being printed. This device needs to be mass production ready.... And the mass produced would not be more than $17 So the component selection is important You make the complete device and send Go through the hardware and software again We need a webserver where all the data from the device is seen/storef You can use *STN1110* It's a multiprotocol OBD-II to UART Interpreter IC.

Automotive

Circuit Design

Electrical Engineering

Electronics

GPS

Prosjekt-ID: 16538551

Om prosjektet

2 forslag

Eksternt prosjekt

Aktiv 6 år siden

Ønsker du å tjene penger?

E-postadresse

Fordeler med budgivning på Freelancer

Angi budsjettet og tidsrammen

Få betalt for arbeidet ditt

Skisser forslaget ditt

Det er gratis å registrere seg og by på jobber

2 frilansere byr i gjennomsnitt $203 AUD for denne jobben

@msppatil401

Hi sir, I understand your requirment we already done this but given price it not possible to do . I will do only hardware reaming software work you have to take care . I'd like to hear from you soon. Best Regards

$250 AUD om 7 dager